Website
37
7.13 Range Test
This function is used to test whether wireless communication between the transmitter
and the receiver is normal.
As the actual remote control distance between transmitter and receiver is far, it is hard to
test whether the radio frequency is normal by controlling a distance of several hundred
meters between the transmitter and receiver in practice. Theoretically, the remote
control distance in this function will be reduced to 30-40 meters. So, you can test whether
wireless communication between the transmitter and the receiver is normal at a close
distance when the function is enabled. This can save testing time.
Setup:
1. Make sure the transmitter and receiver are bound.
2. Enter the [Range Test] menu and press the SW1-R button.
3. Have one person hold the transmitter and stay in place as someone else slowly walks
away from the transmitter with the model.
• Please make sure the transmitter is installed with phone holder, with use of the
standard firmware.
•
Make sure that the transmitter antenna is unobstructed and that there are no
objects or sources of interference between the transmitter and receiver.
4. Check the RSSI on the receiver to make sure that the signal is strong and stable.
7.14 Low Signal Alarm
This function is used to enable or disable the low signal alarm function.
[Low Signal Alarm] If checked, the system will alarm automatically if the signal strength
of the receiver is lower than 30.
7.12 BVD Voltage Calibration
The BVD voltage is calibrated in the post-factory settings. This function can be used to
calibrate when there is a large deviation between the detected voltage and the actual
voltage.The BVD voltage value can be adjusted in the range of 0 to 100 V.
Setup:
Connect the BVD detection line correctly before setting, and then perform calibration.
Note: please refer to the voltage value of multimeter for calibration.
1.Click [BVD voltage calibration] to enter the function setting interface.
2.Click the "+" or "-" to change the battery voltage value as needed.
3.Click [Calibrate]. After successful calibration, click "Yes" in the pop-up window reminder.
• This function can be set in case of an enhanced receiver.
