Fluke PG9000 Series, Руководство по эксплуатации и обслуживанию

Страница: 116 / 202

PG9602™ OPERATION AND MAINTENANCE MANUAL
© 2011 Fluke Calibration Page
106

OPERATION
Note
PG9000 is delivered with NO active password so access to the
User Level menu is open. The User Level is set to <2Low>.
User Levels can be changed freely until a password has been
created. Reset functions (see Section 3.12.9) do not affect the
password setting.
To access the User Level function, press [SPECIAL] and select <2level> .
If no password yet exists or if the correct
password has been entered, the display is:
1change user level
2edit password
Selecting <1change user level> brings
up the restriction menu:
Restriction: 1none
2low 3medium 4high
You can then select the current restriction level, or press [ESC] to return to the
main run screen.
Selecting <2edit password> displays the
user password and allows it to be edited.
Passwords can be up to six numbers in
length and cannot start with a zero. Password: pppppp
0 disables password
If 0 is entered as the password value, then the password is made inactive and a
password will NOT be required to access the User Level menu. This is the
factory default with a security level of
<2low> .

Caution
Once a password has been entered, the User Level cannot be
changed without reentering the password.
If there is an active password, the
PG9000 password entry screen appears.
PG9000 NS nnn-xx
Password: pppppp
The user must enter the user defined password or the factory secondary
password to proceed. When a password is entered correctly, operation proceeds
to the
<1change user level 2edit password> screen.
The first field, < nnnn>, is the serial number of PG9000, followed by a second
field, < xx>. That counts the number of times that a secondary password has
been used. This second field increments each time a secondary password
is used. The third field, <
pppppp >, is for standard password entry.
The factory secondary password is available in case the user’s password has
been misplaced or forgotten. It can be obtained by contacting a Fluke Calibration
Authorized Service Provider. The factory
secondary password is different for all
PG9000’s and changes each time it is used.
3.12.5 <5remote>

PURPOSE
To configure the PG9000 COM1, COM2, COM3, COM4 and IEEE-488 communication ports.
To test COM1, COM2, COM3 and COM4 communications.