Fluke 9000A-Z80QT, Инструкция по эксплуатации

Страница: 16 / 108

ZBOQT
Be
sure
to install the
ribbon
cable plug correctly in the UUT micro-
processor socket.
The self test socket
is
intended
for
use with the
ribbon
cable plug only. Do
not insert any
microprocessor
removed
from
a UUT, or any
other
device
into this socket.
Connect the pod between the mainframe and the UUT as follows:
2-3.
1.
Remove power
from
the UUT. Remove power from the mainframe.
2.
Using the
round
shielded cable, connect the pod to the mainframe
as
shown in Figure
2-1
(for 9000 Series) or Figure 2-2 (for 9100 Series).
Secure the
connector
using the sliding collar.
3.
Apply power to the mainframe.
4.
Perform
a
self—test
of
the pod as described
in
Section
5
ofthis
manual.
5.
With UUT power off, unplug the microprocessor from the UUT.
6.
On the
pod, turn
the self test socket thumbwheel to release the plug
from the self test socket.
7. Align the
ribbon-cable
with the microprocessor socket on the UUT
so
that
the
notched corner
ofthe
ribbon
cable plug aligns with pin
1
of
the
socket. Insert the plug into the socket as shown in Figure
2-3.
8.
Electrically reassemble the UUT. Use extender boards if necessary.
CAUTION
Make sure mainframe power
is on before turning UUT
power on
in
order to activate pod protection circuits.
9. Apply power to the mainframe and the UUT.
POWER CONNECTIONS
The pod receives
+5 volts, -5 volts, and +12
volts from the mainframe. No
external power connections are required.
2—2