4 Product description
4.2 Handling concept
FLUXUS G831ST-HT
2021-06-01, UMFLUXUS_G831ST-HTV1-0EN
18
When starting up the transmitter for the first time, settings relating to the language, time, date and system of units have to
be made. Then the program branch
Parameters
will be displayed.
At later start-ups the measured values will be displayed in case the measurement had not been stopped before the
transmitter was disconnected from the power supply. If the measurement had been stopped, the program branch
Parameters
will be displayed.
After starting the measurement, the parameter settings or the configuration of the transmitter outputs can be displayed at
any time without interrupting the measurement. A change of the parameter settings is not possible during the
measurement. The measurement has to be stopped in order to change the parameter settings or configuration of the
transmitter outputs.
Tab. 4.1:
Description of the program branches
Program branch
Description
Parameters
Before starting a measurement, the transducer, pipe and fluid parameters have to be entered in the
program branch
Parameters
.
Measurement
Having entered the parameters for the measuring point, the measurement can be started in the
program branch
Measurement
.
Options
Settings are carried out in the program branch
Options
, e.g., selection of the physical quantity and
unit of measurement, input of the damping factor, configuration of the outputs, assignation of the
inputs.
Special functions
Global settings relating to the transmitter are carried out in the program branch
Special
functions
, e.g., system settings (language, key lock), measurement settings, communication, data
logger, snaps, configuration of inputs.
