Flavor Burst FB 80Sa-08, Руководство пользователя

Страница: 52 / 76

51
7. Uncap the 9-Tube Assembly and insert the
manifold end fully into the Blending Head
syrup line opening. Rotate it until motion
stops to secure. (See Figure 134.)
26044
Figure 134
Mounting the 9-Tube Assembly Casing
The 9-Tube Assembly Casing should be
mounted on the side of the freezer so that it is
level horizontally. It should be mounted at the
same height as the Blending Assembly so that
the syrup lines are level with the connection at
the Blending Head.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Casing will be attached on the side of the
freezer. The Casing should be attached on
the side that the 9-Tube Assembly tubes
wrap around to the back of the freezer. It
should also be installed at the same height
as the Blending Assembly and should be
level horizontally.
3. Thoroughly clean, rinse and dry the area
where the Casing will be mounted using
detergent water, clean water, and single
service towels. (See Figure 135.)
Figure 135
4. Remove the protective adhesive tape from
the Casing and mount the Casing to the
area on the freezer. (See Figure 136.)
Figure 136
5. Pry open the 9-Tube Assembly Casing.
(See Figure 137.)
R A
N
E
E
26162
Figure 137
6. Place the 9-Tube Assembly, the Keypad
Cable, and the Motor Cable inside the
Casing. (See Figure 138.)
26162
Figure 138
7. Close the Casing, and press all along the
connection to secure. (See Figure 139.)
26164
Figure 139