Flavor Burst FB 80Sa-08, Руководство пользователя

Страница: 40 / 76

39
7. Place only the Blending Head portion in an
approved sanitizer solution, keeping the
Drive Motor above the water line. Press
WATER / SYRUP FLUSH to sanitize the
enclosed auger. Allow the Blending Head
to soak for at least 1 minute. (See
Figure 87.)
WATER
LINE
DRIVE
MOTOR
Sanitizer
26066
Figure 87
8. Remove the Assembly and the o-ring from
the sanitizer and place them on the sanitary
tray to dry. (See Figure 88.)
26199
Figure 88
9. Apply food-grade lube to the o-ring and
place the o-ring into the Blending Head
syrup line opening. A small tool may be
used to ensure the o-ring is fully seated in
the o-ring groove. (See Figure 89.)
26021
Figure 89
NOTE:
O-RINGS MUST BE COMPLETELY
SEATED TO PREVENT LEAKAGE.
Miscellaneous Cleaning Procedures
The following parts of the FB 80Sa do not
require daily cleaning. Inspect these areas
periodically and clean if necessary according to
instructions.
Mix approved detergent with warm water
according to manufacturer’s instructions. Also
prepare approved sanitizer solution according
to manufacturer’s instructions.
NOTE: DO NOT USE AN EXCESSIVE
AMOUNT OF WATER OR DETERGENT IN
CLEANING THE OUTSIDE OR INSIDE OF
THE CABINET.
Area Under the Cabinet
Figure 90
1. Carefully move the cabinet to an area
outside of where it was sitting.
2. Clean the area using a single service towel
moistened with warm detergent water. Use
a brush if necessary.
3. Rinse area with a single service towel and
clean, warm water and then wipe dry with a
dry single service towel.
4. Clean the outside and underside of the
cabinet using detergent, water and single
service towels.
5. Carefully return the cabinet to its original
place.