Flavor Burst FB 80Sa-08, Руководство пользователя

Страница: 38 / 76

37
4. Clean the two o-rings and the Spout
Adapter with a small brush and detergent
water, and rinse thoroughly. (See
Figure 77.)
Figure 77
5. Place the parts in approved sanitizer
solution and soak for at least 1 minute.
(See Figure 78.)
Figure 78
6. Remove the parts from the sanitizer solution
and place them on a sanitary tray to air dry.
(See Figure 79.)
Figure 79
7. Lube the black o-rings and install them in
their respective positions on the Spout
Adapter. (See Figure 80.)
Figure 80
8. Clean the freezer door and spout according
to manufacturer’s instructions before
installing the Spout Adapter on the freezer
door.
9. Set the Adapter on a flat, clean surface, and
then place the freezer door spout upright
onto the Adapter. Rock the freezer door
forward to snap the Adapter into place.
(See Figure 81.)
Figure 81
10. Return the freezer door to the freezer with
the Spout Adapter attached.
Replacing Blending Head O-Ring
The Blending Head o-ring is a wear item and
will need to be replaced periodically. Always
keep a spare of this item on hand in the Spare
Parts Kit for replacement.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also prepare approved sanitizer solution
according to manufacturer’s instructions.