Flavor Burst CTP 80SNS-L, Оборудование, техническое обслуживание и эксплуатация: Руководство

Страница: 62 / 75

61
17. Change Switch Input Ensure the switch
cord from the flavor burst Door Assembly is
fully plugged into the freezer. Press the
CHANGE SWITCH INPUT button to detect
the switch’s port. By default, Wired Switch
Port 1 is selected. Press ACCEPT.
NOTE : IF YOU GET A MESSAGE THAT
SAYS “NO SWICHT DETECTED”, EITHER A
SWITCH IS NOT CONNECTED PROPERLY
OR IT IS NOT ACTIVATING. CONTACT A
TECHNICIAN.
18. Enable Weight Sensor / Enable Auto-
Dispense Lift Ensure the weight sensor
and auto-dispense options are both
activated for the fully-automatic mode and
are both in the ON position.
19. If you are satisfied with the settings of the
Equipment Setup Wizard, press SAVE
CHANGES. You can revert back to your
previous settings by pressing REVERT
CHANGES.
Priming the Syrups
The priming function fills the syrup line with new
or fresh syrup. This is done when first setting
up the Flavor Burst system with all new syrups,
and sometimes when switching flavors and
after the syrup line has been flushed with
sanitizer solution. It is also done to prime the
lines with fresh syrup, since syrup can lose its
flavor if it has been sitting in the syrup line for a
few days without use.
1. Place cup firmly in the cup holder. Allow the
cup to rest freely.
NOTE: DO NOT HOLD OR DISTURB THE
CUP WHILE THE SYSTEM IS DISPENSING.
2. Press the “Priming Functions” section in the
Maintenance Menu. Enter the Administrator
Password if prompted.
3. Select the flavor of the syrup line you are
priming. Flavor will dispense immediately.