Fisher & Paykel RX256DT4X1, Руководство по обслуживанию

Страница: 80 / 108

321023
80
11.1.10 Crisper Light Cover and Socket
1. Push down and forward on the light cover and lift off the tabs.
2. Remove the light bulb and pry the socket with a taped putty knife to release the socket from the liner.
3. Disconnect the wires from the socket.
4. Reverse the procedure to reassemble.
11.2 Freezer Compartment
11.2.1 Freezer Light Socket
1. Remove the auger ice bucket.
2. Remove the auger motor assembly (refer to Section 11.2.2).
3. Remove the light bulbs.
4. Disconnect the wiring from the light sockets.
5. Squeeze the retaining tab to release the sockets.
6. Reverse the procedure to reassemble.
11.2.2 Auger Motor Assembly
1. Remove the auger ice bucket and the fast freeze shelf.
2. Remove the light bulbs
3. Remove the two hex head screws, one from each side of the cover.
4. Lift and slide the assembly toward the front. Disconnect the wiring harness and remove the
assembly.
11.2.3 Auger Motor
1. Remove the auger drive hex nut.
2. Remove the three hex nuts holding the auger motor to the assembly.
3. Disconnect the wires from the auger motor capacitor.
4. Reverse the procedure to reassemble.
11.2.4 Auger Motor Capacitor
1. Remove the auger ice bucket and the fast freeze shelf.
2. Remove the auger motor assembly (refer to Section 11.2.2).
3. Disconnect the leads from the capacitor. Remove the hex screw and remove the capacitor.
4. Reverse procedure to reassemble.
11.2.5 Evaporator Fan Motor Assembly
1. Remove all freezer shelving.
2. Remove the lower evaporator cover hex head screws.
3. Remove the evaporator cover.
4. Disconnect the evaporator fan wiring and ground from the motor.
5. Raise the top freezer cover about 50mm.
6. Grasp and pull the complete evaporator motor assembly forward.
7. Remove the assembly from the freezer.