321023
25
6.2.1
Ice Dispenser Operation
To Dispense Ice:
Select Crush or Cube mode by pressing the appropriate keypad on the dispenser control panel. A
green light above the keypad indicates the mode selected.
Press a container against the dispenser pad. When dispensing crushed ice, hold the container as
close as possible to the chute to reduce spraying.
NOTE:
The mode cannot be changed while the ice dispenser is in operation.
On selected models, if the dispenser is active for more than five minutes, an automatic lock-out
sensor will shut down power to the dispenser area. Refer to
Dispenser Lock
below for unlocking
information.
6.2.2
Dispenser Lock (Selected Models)
The Dispenser Lock prevents ice or water from being dispensed.
To Lock Dispenser:
Press and hold the LOCK keypad for three seconds. The green indicator light above the keypad
will illuminate when the dispenser is locked.
To Unlock Dispenser:
Press and hold the LOCK keypad for three seconds. The green indicator light above the keypad
will go out.
6.2.3
Water Filter Status Indicator Light (Selected Models)
The Water Status Indicator Light serves as a reminder to replace the water filter. A green light
indicates that the filter is in good condition. A red light indicates that the filter should be changed.
Once the light turns red, it will remain red until the function is reset.
To Reset Indicator:
Press and hold the
LOCK
and
WATER
keypads simultaneously for four seconds. The green filter
status indicator light will flash three times when the function has successfully reset.
6.2.4
Auto Light (Selected Models)
The Auto Light function activates the dispenser light at half power when the light sensor detects that
the light levels in the room are low.
To Activate Auto Light:
Press the
AUTO LIGHT
keypad. A green indicator light above the keypad illuminates when the
sensor is active.
To Deactivate Auto Light:
Press the
AUTO LIGHT
keypad. The green indicator light will go out.
NOTE:
The dispenser light will operate whether Auto Light is ON or OFF.
6.2.5
Light (Selected Models)
To Activate Light:
Press the
LIGHT
keypad to turn the dispenser light on continuously. The green indicator light
above the keypad will illuminate.
To Deactivate Light:
Press the
LIGHT
keypad to turn the dispenser light off.
Содержание RX256DT4X1
