Festo CPX-CMAX-C1-1, Монтаж, установка и диагностика

Страница: 35 / 176

2. Fitting and pneumatic installation
2−5
Festo P.BE−CPX−CMA X−SYS−EN en 0908NH
Mounting Mount the CMAX as follows:
1. Place the CMAX in the interlinking block. Make sure that
the grooves with the power contact terminals on the bot
tom of the CMAX lie above the contact rails.
2. Push the CMAX carefully and without tilting as far as
possible into the interlinking block.
3. Tighten the screws only by hand. Place the screws so that
the self−cutting threads can be used.
4. Tighten the screws with a size T10 Torx screwdriver with a
torque of 0.9 to 1.1 Nm.
The parameterisation is saved in the CMAX. Therefore, after
replacing a CMAX, check the parameters and, if necessary,
repeat the commissioning process. See chapter 4.
Observe the instructions in section A.2.