Festo CPX-CMAX-C1-1, Монтаж, установка и диагностика

Страница: 112 / 176

4. Commissioning
4−34
Festo P.BE−CPX−CMA X−SYS−EN en 0908NH
3. Step: Start direct mode
Allocation of the control bytes (step 3)
Bit B7 B6 B5 B4 B3 B2 B1 B0
CCON OPM2 OPM1 LOCK RESET BRAKE STOP ENABLE
Byte 1
0 1 0 0 0 1/0 1 1
CPOS CLEAR TEACH JOGN JOGP HOM START HOLD
Byte 2
0 0 0 0 0 0 1 0
CDIR
FAST XLIM VLIM CONT COM2 COM1 ABS
Byte 3
0 1 0 0 0 0 0 0
Secondary
setpoint Byte 4: Setpoint value of the speed: in percentage of the specified value Speed in direct
mode" (PNU540): 70
%
Z
46h
Z
0100 0110b
Primary
setpoint Byte 5 ... 8: Setpoint value of the position in the configured system of units (metric/
linear): 70 mm
Z
00001B58h
Z
0000 0000 0000 0000 0001 1011 0101 1000b
The setpoint values are accepted and MC reset. Wait until the
start is signalled back with SPOS.ACK = 1.
Allocation of the status bytes (step 3)
Bit B7 B6 B5 B4 B3 B2 B1 B0
SCON OPM2 OPM1 FCT_MMI 24VL FAULT WARN OPEN ENABLED
Byte 1
0 1 0 1 0 0 1 1
SPOS REF STILL DEV MOV TEACH MC ACK HOLD
Byte 2
1 x x x x x 1 0
SDIR FAST XLIM VLIM CONT COM2 COM1 ABS
Byte 3
0 1 x x 0 0 0 0
Secondary
actual
value
Byte 4: Acknowledgement of the actual value of the speed in percentage of the set value
Speed in direct mode" (PNU540).
Primary
actual
value
Byte 5 ... 8: Acknowledgement of the actual value of the position or force in the
configured system of units.