AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1300 889 028
MODEL: №. SBC52 • 02/2020 • 700710
52cc 2 Stroke Brushcutter / Line Trimmer
31
the safety lever (9) and pull the throttle trigger (8) on to increase speed.
WARNING.
On start up, the output spindle may rotate under load
so ensure the cutting device is positioned away from other persons,
animals or debris. On release of the throttle trigger (8), the motor must return
to the idle speed and the blade or line must NOT be turning under drive from
the motor.
6. Once the engine is fully warm ensure the choke (red lever) (22) is down
fully to the run position (warm start).
Warm Start
When re starting the unit after it has been used and the motor is hot, there is
no need to engage the choke (red lever) (22). Follow steps 4, 5 & 6 in the
previous section.
A Flooded Engine
If the choke (red lever) (22) has been left in the full choke position and the
engine will not start, it is possible the engine has been flooded (Too much
fuel).
To assist to clear a flooded engine:
1. Move the choke (red lever) (22) to the run or warm start position.
2. Squeeze the safety lever (9), and pull on fully the throttle trigger (8).
3. Check the on/off switch (10) is in the “on” position as indicated by an “I”.
4. Pull the recoil starter (2) a number of times to clear the fuel and start
the motor.
WARNING.
Be aware that if starting occurs with the throttle pressed,
the motor will accelerate and thus engaging the clutch, which will then
rotate the cutting head.
As soon as the motor starts release the throttle so the motor runs at
idle speed and disengages the clutch.
