AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1300 889 028
MODEL: №. SBC52 • 02/2020 • 700710
52cc 2 Stroke Brushcutter / Line Trimmer
21
Changing the line only on the Spool and Line Assembly
NOTE:
Always ensure the engine is turned off before undertaking this
assembly.
NOTE:
The spool provided on this product is a rapid or easy wind type spool.
There is no disassembly of the spool components. The following steps will
guide you through the process.
NOTE:
The spool & line assembly (35) does not need to be removed from the
lower shaft (15) of the line trimmer, however, if it is easier, it can be removed
from the lower shaft (15), especially for the first time you re-load / re-wind
the line & become familiar with the process.
The line to suit this type of spool assembly is 2.5mm diameter line, with a
length not exceeding 2.6m.
1. Remove any existing line protruding from either eyelets in the spool
assembly (35). If there is no line left inside the spool, the line can easily
be pulled outwards from the eyelets. If the line will not pull out and is
jammed, the spool will need to be opened and the jammed line released.
Refer to the section on “Clearing a Jammed
Spool” following this section.
2. Cut a length of 2.5mm diameter nylon line to a
length of 2.6m, ensuring the line is cut cleanly.
If the first 150mm of line is curved, try and
straighten the line as much as possible for entry
into the spool.
3. Align the outwards pointing arrow on the bump
knob (34) with either of the eyelet holes (Fig Y)
on the outside of the spool housing. This will
allow the line to be threaded through the spool
to the opposite side.
4. Insert one end of the line through the eyelet
until it passes through the spool and out
through the opposite side. (Fig Z) The line
should pass through the spool with the first
150mm of line. If it does not pass through the
Y.
Z.
