42
!
"
#
%
&
/
$
Edgebander
G 330 / G 360 / G 380
Inspecting and adjusting settings
The radius scraper removes cutter marks on the PVC
edges.
The settings for the radius are defined using the
horizontal copier pad.
Activate / Deactivate:
Standard equipment: Manual adjustment
To disengage the lower and upper glue scrapers, pull
knob 4, thus moving the unit away from the workpiece.
Adjusting the depth of cut:
1.
Switch the machine off and ensure that it cannot be
switched on again Open the rear access door.
2.
Adjust the depth of cut using the adjusting knobs
until the positioning indicator shows the value of the
edging to be glued on.
Note: Always adjust towards the workpiece to
compensate for the thread backlash.
3.
Check the adjustment and repeat if required.
!
Adjusting knob - Chip thickness
"
Display - Chip thickness
#
Copy shoe
$
Knob to exclude scraper
%
Blade depth adjustment
&
Edging thickness display
/
Dust extraction port
8.11.1 Radius scraping unit
8.11 Radius scraping unit, glue scraping unit (Optional)
Fig. 8-17: Setting - Radius scraping unit
Attention! Risk of material damage!
1) This setting has to be exact.
2) Only use this unit on PVC edging!
The scraping knives and/or the workpieces may be damaged if the setting is incorrect or if material other
than PVC is used.