36
!
!
Edgebander
G 330 / G 360 / G 380
Inspecting and adjusting settings
8.7 Setting the guillotine shears
The guillotine shears cut off the edge material at a
certain distance from the end of the panel.
This unit is only used for veneer, melamine, PVC, ABS,
polyester edging in coils and with a diameter of 3 mm.
The guillotine shears are activated automatically when
the programmes are set at the control panel.
!
Guillotine unit
8.8 Pressure rollers
Fig. 8-9: Setting the guillotine shears
!
Shears from coil
Fig. 8-10: Pressure rollers
This unit serves to help the edging material adhere better
to the workpiece.
The two pressure rollers are mounted onto a plate, which
needs to be set according to the thickness of the edge to
be glued.
The depth of the cylinders can be adjusted by turning the
thumb nuts.
A piece of edging is placed into the free space between
the adjusting screw and the mounting bracket to obtain
the correct contact pressure of the rollers.
The thumb nuts must be tightened so that the inserted
edging material remains in place and cannot fall out.
The correct edging thickness setting has been set.
Caution: if this unit has not been set correctly it could
lead to unsatisfactory gluing results. If the edging thick-
ness has been set incorrectly, it could lead to damage to
the workpiece or the edging material might not adhere
properly to the workpiece.
Attention! Risk of material damage!
The edging material may end up not being glued properly if these units are not set correctly.
Note:
For solid wood edges, the guillotine shears may not be used and must be deactivated.
