35
!
"
#
"
!
Edgebander
G 330 / G 360 / G 380
Inspecting and adjusting settings
Set the depth of cut of the premilling unit as follows:
1.
Loosen the thumb screw 2.
2.
Set the depth of material abrasion, displayed on the
number display, with knob 3.
3.
Tighten the thumb screw 2.
!
Number display
"
Thumb screw 2
#
Knob 3
The side trimming unit consists of two motor-driven
moulders with a diameter = 60 H49 Z2+2. Both
moulders work together, opposite to each other and have
a maximum depth of cut of 0 to 2 mm.
Set the depth of cut on the infeed track.
!
Spindle moulder–Reverse
"
Spindle moulder–Synchronous operation
Fig. 8-8.1: Setting the premilling unit
8.6.1 Operation
Fig. 8-8.2: Setting the depth of cut
8.6.2 Setting the premilling unit
Note:
Exchanging Shaper - See chapter entitled: Maintenance/Service
8.6 Side Trimming Unit (Optional)
