30
$
#
"
!
!
%
Edgebander
G 330 / G 360 / G 380
8.3 Edge tape feeding
Fig. 8-3: Edge tape feeding
This unit's function is to bring together the edging materi-
al with the workpiece.
To clamp the edging material, swing the pressure roller
away with the handle (Pos. 1). The edging material has
to be threaded through right up to the cutting edge of
the guillotine scissors. Release the handle. The edging
material is now fixed in position.
The workpiece movement over the copy roller on the
chain conveyor (Pos. 2) moves the tape feeding roller
(Pos. 3) via a series of gears, and therefore feeding the
edging material exactly to the workpiece.
The height setting (Pos. 4) has to be adapted to the
height of the edge material. This setting prevents the
edging material from raising or lowering itself away from
the workpiece.
You can adjust the height of the bar by turning the thumb
nut (Pos. 4). It needs to be set so that the edging material
can be fed easily and without any resistance.
A second height setting (Pos. 5) prevents the edging ma-
terial from moving upwards in front of the guillotine scis-
sors. You can adjust the height of the pin by opening the
thumb nut (Pos. 5). It needs to be set so that the edging
material can be fed easily and without any resistance.
Attention! Risk of material damage!
The edging material may end up not being glued properly if these units are not set correctly.
Inspecting and adjusting settings
