16
Edgebander
G 330 / G 360 / G 380
Attention!
Authorised noise emissions depend on the specific country regulations in which the machine is operated.
If on a rare occurence, the noise emission should exceed the country specific limits as a result of particular
circumstances, the operator is obliged to provide additional protection against the noise.
4.5 Noise emission
The specified values are emission values and therefore
do not represent safe workplace values. Even though a
relationship exists between particle emission and noise
emission levels, an inference cannot be made about
whether additional safety measures need to be imple-
mented. Factors which can significantly affect the emis-
sion level that presently exists at the workplace include
duration of the effect, characteristics of the workspace,
and other ambient influences. The permissible workplace
values may also differ from country to country. Never-
theless, this information is provided to help the operator
better assess hazards and risks. Depending on the
location of the machine and other specific conditions, the
actual noise emission values may deviate significantly
from the specified values.
Ear protection must always be worn; however, such
protection cannot be considered a substitute for properly
sharpened tools or the correct speed.
The noise emission level was measured with the following workpiece:
Panel material: Chipboard 45 mm
Edge material: PVC 3 mm
An allowance must be made to compensate for tolerances with the specified emission values K = 4 dB.
Without the premilling unit
Sound power level
EN ISO 3746
Workplace emissions values
EN ISO 11202
AP 1 AP 2
Idle
92 dB
72 dB
70 dB
Working
94 dB
73 dB
74 dB
With the premilling unit
Sound power level
EN ISO 3746
Workplace emissions values
EN ISO 11202
AP 1 AP 2
Idle
94 dB
76 dB
71 dB
Working
99 dB
82 dB
76 dB
Technical specifications
