52
!
!
Edgebander
G 330 / G 360 / G 380
10.4 Replacing the burnt glue
1.
Heat the glue to the operating temperature.
Insert two wooden batons into the liquid glue.
2.
Then, leave the glue to cool down completely and
warm up again.
As soon as the glue detaches itself from the walls of
the glue pot, remove the glue from the glue pot with
the wooden batons.
3.
Remove burnt glue residues with a wooden spatula.
Clean the cooled down glue pot with rags and a
glue remover.
!
Wooden batons
Fig. 10-9: Replacing the burnt glue
Warning! Risk of burns and serious injuries!
During filling and re-filling, periodic maintenance and whilst cleaning the glue pot, be aware that the glue
has an operational temperature of 200°C.
Use all suitable methods of protection to prevent severe injury.
The used glue must be disposed of according to the regulations of the country where the
machine is installed.
Maintenance/Service
10.4.1 Replacing the burnt glue (EVA)
Fig. 10-9.1: Replacing the burnt glue
10.4.2 Replacing the burnt glue (PUR)
1.
Activate the standby mode of the glue pot.
Remove burnt glue residues with a wooden spatula.
Use a lint-free cloth for the final cleaning of the glue
pot.
2.
Fill the glue pot with cleaning granules.
Let the machine operate in the idle mode for ten
minutes.
Edge 4 - 5 test panels to remove the last residue of
the cleaning granulate.
3.
Scoop out the glue pot contents with sticks and wipe
them on a panel.
Use a lint-free cloth for the final cleaning of the glue
pot.
Attention! Risk of material damage!
Open PUR glue has to be processed within 6 hours (maximum 8)/manufacturer data sheet
The standard glue pot has to be cleaned :
mechanical removal of glue residue
Daily
Cleaning with cleaning granulate and mechanical removal of glue residue
Daily
