46
#
!
%
$
"
!
§
"
Edgebander
G 330 / G 360 / G 380
The electronic temperature adjuster must be set to the
temperature recommended by the glue manufacturers (in
factory normally adjusted to 200°C)). The glue applica-
tion roller starts automatically once the glue is liquid and
has reached 190°C.
Depending on the type of glue, working temperatures
may be approx. 180°–210° C (356°–410° F).
To ensure that the glue maintains its quality, the glue pot
must be kept at the operational temperature for as short a
time as possible.
Setting the glue temperature:
• Press either SP1 or SP2
• Adjust the value using “+” or “–” and press ENTER to
confirm
!
Operating temperature (SP1)
"
Stand-by temperature (SP2)
#
Digital temperature indicator
$
“+” and “–” set the value desired for SP1 and SP2
%
Enter key
Note: The machine has an automatic temperature reduction system:
If the machine is idle for 20 minutes the temperature will reduce automatically to the SP2 value specified.
If the glue is to be reheated to operational temperature (SP1), then this process can be started by pressing
SP1 twice.
9.3 Setting the glue temperature
Fig. 9-2: Setting the glue temperature
The end trimming unit is activated as standard for straight
end trimming.
Press and hold the >End trimming unit< button for a
few seconds to change the type of cut. Use the arrow
keys to select the front, rear or front and rear caps.
Press >OK< to confirm.
End trimming with radius
After selecting front and rear end trimming, you can
use the arrow keys to select whether straight or radius
capping is to be used.
Press >OK< to confirm.
The LED is lit continuously for straight caps and flashes
when radius caps have been selected.
9.3 Setting the end trimming unit G380
Fig. 9-1: Setting the end trimming unit
!
button End trimming unit
"
Arrow keys
§
>OK< Enter key
Using the controls
