IDENTIFICATION
ID ISC.ANT1710/690 Crystal
Gate Excellence -A/-B
Typical Antenna Configuration
Page 38 of 38
7.4 Testing the Gate Antenna
After tuning the gate antenna, you can check for proper function using a reader, the ISOStart service
software and a transponder. At this point, the noise level and performance of the gate are tested.
7.4.1 Checking the Noise Level
Step
Action
Note
1
Activate antenna 1 with the
command: „Function Unit
Commands - Multiplexer“
Parameter:
„Channel Select“
„Cascade Level = 1“
„Output Channel of Input 1 = 1“
2
Confirm with “Send”
3
Activate “Test and Measurement”
4
Select „Noise Level“ and start by
clicking on „Start“
5
Normal Noise Level values:
Average:
< 30mV
Difference (Max-Min):
< 20mV