Fastrax IV, Инструкция по эксплуатации, Страница: 83 / 92

77
1. INTRODUCTION
The mount kit of the speed dome housing is easy and it is suitable in the installation quick.
The mount kit is constructed of die-case aluminum and steel.
2. INSTALLATION
The wall or ceiling mount must be attached to a structural object such as hard wood,
concrete that will support the weight of the mount and AIO.
The use of a solid backboard is recommended when attaching to gypsum walls.
1. Attach the mounting base to wall using the supplied M8 tapping screw and plastic bushing.
(Ceiling using the supplied M6 tapping screw and bushing)
2. Wind the both thread of the pipe end with Teflon tape about 20times for sealing.
Then use a silicone rubber sealant to seal the area where the wall (ceiling) mount and the
pipe meet.
3. Place a bead of silicone sealant around the wall and ceiling mount mounting flange, press
it to the surface and line up the flange hole with drilled holes.
CAUTION : A silicone rubber sealant must be applied to seal the housing to secure
waterproofing.
2.1 WALL MOUNT KIT
Note : Refer to Parts List.
1. Mark and drill mounting holes in the surface using the Wall Mount Flange.
2. Pull out cables required to connect to the dome camera from the wall or route cables
through a section of 0.75 in. (19mm) conduit pipe.
3. Remove the access plate from the wall mount bracket.
4. Attach the wall mount bracket using screws routing cables through the access plate's hole.
5. Attach the housing's safety wire to the wall mount's latch.
6. Fix the housing to the wall mount bracket using the locking nut after routing cables through
the wall mount bracket and tighten the housing set screw with the supplied wrench.
7. After connecting cables, attach the access plate.