Fastrax IV, Инструкция по эксплуатации, Страница: 30 / 92

24
Follow steps below to set the Enter:
1. Set the min size of the enter object and set the max size.
2. Select the enter base.
3. Select the “Set Point” for enter box.
4. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the
program without saving.
3.5.6 Abandon
This can detect an object abandoned in a specified area.
You can see current status of moving object by “Bounding Box”.
Once moving object is fixed as “Abandon”, color of “Bounding box” will be changed to
complementary color of ROI line.
(“Bounding box” means you can see a virtual rectangle on moving object. In prior of this, you
make sure that you set “On” in display and Bounding box in OSD Setup.
Min. : Set the min size of object while object abandoned.
Max. : Set the max size of object while object abandoned.
Event Time : Set the event time.
10s,20s,30s,40s,50s,60s,70s,80s,90s,100s,120s,180s,240s
Set Point : Set the abandon box.
Clear : Remove the abandon box.
Follow steps below to set the Abandon:
1. Set the min size of the enter object and set the max size.
2. Select the event time.
3. Select the “Set Point” then draw a box for two point.
4. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the
program without saving.
Note : There might be malfunction of Removal for the following cases:
- The object brightness is almost identical to the background luminance
- When the objects are either large or small in comparison to the preconfigured
Object size