Fastrax IV, Инструкция по эксплуатации, Страница: 32 / 92

26
3.6 Shortcut of Preset Program
After selecting the desired scene, press No. (1 to 240), and press CTRL and PRST
subsequently. The current view will be stored to the selected preset number if the preset
number is empty. If selected preset number is not empty, “Do you want to overwrite preset?”
message will be displayed on the monitor and select the “OK” and push the Joystick to the
right to overwrite.
Example: 1 , 0 , 1 + CTRL + PRST will store current view as preset No. 101. In this case,
focus will be programmed as Auto, dwell time will be set to 3 second, and the current AE
mode will be programmed.
3.7 Tour
(SHORTCUT: TOUR)
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns,
Scans or other Tours (second-level). Using second-level tours, it can be expanded to over
300 functions in a single tour.
Number : 01 -08
Title : up to 12 characters.
Scan Type : Normal, Vector
Normal : Move from start point to end point in panning only.
Vector : Move from start point to end point including tilt and zoom simultaneously and
linearly. In some model, the zoom is fixed at wider angle and the zoom
magnification information is not displayed.
Speed : 1 - 13 steps, the lower number means the slower speed.
Event Enable : ON / OFF
ON : Enable all events except abandon and removal preconfigured in preset.
OFF : Disable all events preconfigured in preset.
Tour List : Display the stored function list (Preset, Pattern, Auto Scan, Tour List) or
you will set the desire function list.
Follow the steps below to program the Tours:
1. Press MENU to display the main menu on the monitor. Scroll to Tour and push the
Joystick to the right to enter the Tour menu. Or just press the TOUR key on the
keyboard.
2. Select the” NUMBER” and set the desired number by pushing the Joystick left or right.