Fastrax IV, Инструкция по эксплуатации, Страница: 27 / 92

21
3.5.3
.
Tracking
You can make a camera follow the moving object automatically (In case of catching more
than 1 moving objects at the same time, a bigger object will be tracked)
Zoom Enable : Set to enable or disable linked zoom capability during tracking.
Return Time : Set the dwell time before move to previous position once tracking is
inactive. (Off, 3~99 seconds.)
Lost Mode : Choose “Stop” or “Zoom Out” when object has been lost.
Stop : Stop Tracking in current position when object lost.
Zoom Out : “Zooming Out” will be activated in 3 seconds after object was lost.
However this can not work if you switched off “Zoom Enable”.
Object Size : Set the min/max size.
Exclusion Area : Set the exclusion area.
Follow steps as below to set the Tracking:
1. Set the Zoom Enable.
2. Set the lost mode.
3. Select the object size and the exclusion area.
Follow the procedure of the detection above to the object size and the exclusion area.
4. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the
program without saving.
Note : If you set to the sensitivity of tracking, select the motion in event function. Then
set to the sensitivity of motion. Select to the tracking in event function again.
Note : Auto tracking will be activated with an indicator (+) focused on the center of the
object
Note : Malfunctions in Auto Tracking might occur for the following cases:
- The object brightness is almost identical to the background luminance or in
environments with extreme low light conditions
- Water drop or damp on the Dome’s Bubble
- An environment with extreme changes in illumination
- An environment where there is excessive other non-target movement
- An environment where there is extreme twinkling or lambency on the object
- Movement too close to the camera optical axis
- Movement of the target in the vicinity directly below the camera