Fastrax IV, Инструкция по эксплуатации, Страница: 51 / 92

45
2. Select Function Number and push the Joystick to the up or to the down. The recorded
function number will list.
3. Select WATING Time and push the Joystick to the up or to the down to select from 10 to
240 seconds.
4. Select Function Enable and turn to ON or OFF by pushing the Joystick to the up or to the
down.
3.18 View Angle
FLIP: OFF,90
°
,100
°
,110
°
,120
°
,AUTO
OFF: The dome camera moves until 90
°
vertically.
90
°
, 100
°
, 110
°
, 120
°
: allows the image to flip digitally when the camera moves over the
setting angle vertically.
AUTO: When the camera reaches the floor directly above the moving object, it will stop.
At that time, release the Joystick handle instantly and pull it down again to run the auto-
flip function. When you use the panning range, we recommend using the flip mode to
AUTO.
TILT OVER ANGLE:
This option is used to set the limit of the horizontal view angle so that the trim ring or
ceiling does not obstruct the horizontal image when zooming out (wide angle).
ON: In some installations it is desirable for the dome camera to be able to see above the
horizon. When this option is chosen, the dome will tilt up over the horizon (About -10
degrees). When the lens is zoomed out, you can see the ceiling line. But when the lens
is zoomed in, the viewing angle is narrower, and the ceiling line disappears.
Without Bubble: The tilt range of the camera is limited to see the horizon so the picture
shows part of the ceiling line.
With Bubble: The tilt range of the camera is limited to see below the horizon
(10 degrees).
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin
Offset of tilt angle as described below.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.