Fastrax IV, Инструкция по эксплуатации, Страница: 77 / 92

71
2. DESCRIPTION
The Indoor/Outdoor dome housing is used with dome camera. The housing is constructed of
aluminum, steel and plastic. The housing is designed to be mounted on both the wall and the
ceiling. The housing meets international IP66 standards for dust and moisture resistance.
Sunshield model is available for application to avoid the direct rays of the sun.
3. INSTALLATION
Refer to the pages of 6. PARTS LIST.
1. Attach a mounting base on the ceiling or the
wall using tapping screws (Ceiling Mount : M6,
Wall Mount : M8, Power Box : M6) and plastic
bushings.
CAUTION :
For safety, the structure that a mounting base is
installed on should be strong enough to support
a minimum of 25kg (55.1 lb).
For safety, a mounting base should be strong
enough to support a minimum of 19.8lb (9kg).
2. Wind Teflon Tape around the thread of "A" (Figure 1.)
about 20 times for seal.
3. Pull out all the required cables through a mounting base and its pipe.
4. Fit "A" that Teflon Tape is wound around to the base and turn this unit until it is securely
fastened.
5. Connect the power connector of 24VAC of the cables to "AC IN" of fan & heater board
○
23 .
6. Connect the power, the Alarm and the communication lines in the cables to the connectors
of the Base Board of the Dome Camera.
7. Fasten the Dome Base on the Screw Spacer
○
18 using 3 screw(BH M4xL8)
8. Attach the Dome Body to the Dome Base. After aligning the arrow mark of the Dome Base
with the unlock mark of the Dome Body, turn the Dome Body to the lock mark direction.
Note : It is recommended to remove the Window and the Bubble Ring Ass'y of the
Dome Camera to improve the quality of picture. (Refer to the Figure. 2)
9. Insert the Rubber Gasket
○
7 into the Body
○
6 and fasten the Bubble Ring
○
11 to the
Body
○
6 using 3 screws
○
13 .