Fastrax IV, Инструкция по эксплуатации, Страница: 29 / 92

23
Use the Joystick to set the location of the start point(yellow mark). Move the cursor (green
mark) by pushing the Joystick, up, down, right or left. Select the location of the end point.
Draw a cross line to end point from start point.
5. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the
program without saving.
Note : To minimize failure rate of “Cross”, you are recommended to draw horizontal
Cross line than vertical line. Also cross line should be placed on the position where
object is passing fast.
Note : Malfunction might occur or the cross will be deactivated if the moving object
reaches the edge of the Cross-line.
3.5.5 Enter
This can detect a moving object that newly enters in a specified area (enter box).
You can see current status of moving object by “Bounding Box”.
(“Bounding box” means you can see a virtual rectangle on moving object. In prior of this, you
make sure that you set “On” in display and Bounding box in OSD Setup.
Min. : Set the min size of object while object entered.
Max. : Set the max size of object while object entered.
Base : Set the reference point while object entered.
It occurs a event when reference point enters in a specified enter box.
Top : Reference point is the top of object.
Bottom : Reference point is the bottom of object.
Both : Reference point is the top of object and bottom of object.
Set Point : Set the enter box.
Clear : Remove the enter box.