IL3 User’s Guide
page 8
11S-3002B
*The 17.5mm diagonal @ 1024 x 1024 is slightly larger than the 16mm specification for 1” C-mount
lenses. Many, but not all 1” format lenses will satisfactorily cover this resolution.
This table assumes that the images are centered (no custom offset applied). (See “Appendix C: IL3
Record / Resolution Tables” on page 82.)
Note: All F-mount and PL-mount lenses will easily cover the full 22.9m full resolution image plane.
2-3 Power
Attaching the External DC Power Supply
The 12V DC Power Supply operates on 100-240VAC, 50-60Hz. The socket is a standard IEC 13, used
worldwide for all types of electronic equipment. The power supply is shipped without power cord so
that the user may use one appropriate for local power outlets.
1. Attach a power cord to the power supply and connect it to an AC power outlet.
2. Attach the power supply output cord to the camera via the LEMO connector. Note that the LEMO
connector is keyed: the red dot on the connector will face the back of the camera.
3. The camera will automatically begin to boot as soon as power is applied. While powering on, the
green camera LED will light up for a 15 seconds and go off, then the green power LED will light up.
After about 45 seconds, when both power and camera LEDs are lit, the camera is fully booted. If
attached to a network, the amber network LED will blink occasionally.
Note: There is also an ON/OFF button located on the backside of the camera. This can be used to turn
the camera on and off while power is applied. It is also used to manually update the camera.
2-4 IL3 Memory and Mass Storage Options
The IL3 camera is equipped with 4GB or 8GB of internal high-speed internal memory that can be
partitioned for one or more image sequences. Images stored in this memory may be reviewed on the
camera, external monitor via HDMI, or PC, then saved to any of four types of mass storage devices:
1. Solid State Hard (optional) drive installed in the IL3 at the factory.
2. SD-Cards (SDHC) inserted by the operator into the SDHC slot on the side of the IL3.
3. USB devices such as thumb drives or USB external hard drives connected via the USB port.
4. Memory devices on a networked PC using Fastec Camera Control (not Web Browser).
Resolution
Sensor Diagonal Required Lens Format
to avoid noticeable
Vignetting
Field of View From 10M with
50mm Lens
1280 x 1024
22.9mm
1.3”
3.6 x 2.9M
1024 x 1024
17.5mm
1.3”*
2.9 x 2.9M
800 x 600
14mm
1”
2.2 x 1.7M
640 x 480
11.2mm
2/3”
1.8 x 1.3M
256 x 200
4.5mm
1/3”
.72 x .56M
Table 2-2:
Lens Selection
Содержание IL3
Страница 1: ...IL3TM High Speed Camera Operator s Manual 2013 9 110S 3002B...
Страница 71: ...IL3 User s Guide 11S 3002B page 63 Figure 7 4 High Mid and Low 8 Bits of the same Image...
Страница 102: ...IL3 User s Guide page 94 11S 3002B Appendix J Physical Measurements Figure 8 10 Physical Measurements...
