IL3 User’s Guide
11S-3002B
page 13
3-2 Connect the IL3 to a Wired Network
The IL3 requires a network connection for setup and control via Fas
M
otion software or the built-in
Web-App. This section addresses the use of Fas
M
otion. For details on the Web-App see”6 Using the
Web App” on page 52.
The default network configuration for the IL3 is DHCP. If a DHCP host is not found on the network, the
IL3 will automatically configure itself with a 169.254.xxx.xxx IP address according to Gig-E protocol.
To attach the IL3 to a network:
1. Before connecting to power, connect the
IL3 to your network via a switch or router,
or directly to your PC using CAT 5E or CAT 6
Ethernet cable.
2. Power up the IL3. See “2-3 Power” on page
8.
3. Watch the LEDs on the camera’s RG-45
connector. When the camera connects to the
PC or local network the green LED will begin
to blink in a pattern depending on connection
speed. (See “Table 3-1: IL3 Network LEDs” on
page 13.)
4. Start the Fas
M
otion software application.
5. Click on the “Find Camera” icon, circled in red
on the figure shown here, to open the Find
Cameras dialog.
6. Click on the Local Area Connection drop
down to get a list of available network
interfaces. Select the one you wish to use.
Note: It is possible to use a wireless adapter on
your PC, but it is not recommended because of
performance issues.
7. Click on the Scan button. Fas
M
otion will list
the cameras found available on the selected
interface.
8. Select the camera you wish to connect to
from the list and click on Connect. Cameras
are listed by MAC address. The camera serial
number is the last two digits of the MAC
address.
9. Make sure the “Stream Video Upon
Connection” box is checked if you wish to
view live video when the camera connects.
Note: If the camera you are looking for does
not appear on the list, you can click on the Find
Manually button and enter its IP address.
LEDs on RJ-45 Connector
Camera
Networking LED
Green (Connection) Amber (activity) Amber (activity)
1 Blink = 10Mb
Blinks for all
network activity
Blinks for camera
network activity only
2 Blinks = 100Mb
3 Blinks =1Gb
Table 3-1:
IL3 Network LEDs
Figure 3-6:
FasMotion “Find Camera” Icon
Figure 3-7:
FasMotion “Find Cameras” Dialog
Содержание IL3
Страница 1: ...IL3TM High Speed Camera Operator s Manual 2013 9 110S 3002B...
Страница 71: ...IL3 User s Guide 11S 3002B page 63 Figure 7 4 High Mid and Low 8 Bits of the same Image...
Страница 102: ...IL3 User s Guide page 94 11S 3002B Appendix J Physical Measurements Figure 8 10 Physical Measurements...
