IL3 User’s Guide
11S-3002B
page 57
6-6 Display Settings Tab
“Figure 6-10: Display Settings Tab”, is shown with the /Bit Depth
and White Balance selection boxes open.
Settings in this tab control displayed images, both Live and in
Review, and all saved images except the RAW formats.
The Display
Bit Depth
selection box will only be present when
the camera has been placed in 10-bit mode in the Record
Settings Tab. (See “Figure 6-8: Record Settings Tab--Advanced
Settings”.) For more detail on bit selection see “Application Note
2: Understanding Bit Depth” on page 62.
Select
White Balance*
preset according to the available light.
The sliders used for
Brightness, Contrast, and Gamma
you
control over the same range as with the presets in the camera,
but it is a much finer control.
The color sliders* give you control over the RGB gains. It is
advisable to use the color sliders with a grey card to get good
color balance:
1. Frame the camera image on a neutral gray object. (A gray
card, piece of white paper, white wall etc.)
2. Turn on the histogram on the camera display.
3. Adjust the light or F-stop so that the histogram shows most
pixel values in mid range. You will see a separate peak for
Red, Green, and Blue. Green will likely be highest.
4. Adjust the gains for Blue and Red up so that the peaks
match the Green.
(* Color cameras only.)
6-7 Arm, Trigger, Live, and Review Buttons
Use the Arm, Trigger, Live, and Review
Buttons above the image window to
control the state of the camera:
When the camera is in Live mode with
no captured images in its buffer, the
Arm
and
Live
buttons will be enabled
(bright) and the Trigger and Review
buttons will be disabled (grayed).
Click on the
Arm
button whenever it is
enabled and to go into Record mode.
This will arm the camera, recording the
pre-trigger frames.
The Arm button will now turn Brown
and change to “Armed.” The Trigger button will become enabled. Clicking on the
Armed
(brown)
button, will de-arm the camera (after a warning message), just like pressing the mechanical Arm
button on the camera while the camera is recording.
Clicking on the
Trigger
button (or using the external hardware trigger, if enabled) will cause the
Figure 6-10:
Display Settings Tab
Figure 6-11:
Arm, Trigger, Live and Review Buttons
Содержание IL3
Страница 1: ...IL3TM High Speed Camera Operator s Manual 2013 9 110S 3002B...
Страница 71: ...IL3 User s Guide 11S 3002B page 63 Figure 7 4 High Mid and Low 8 Bits of the same Image...
Страница 102: ...IL3 User s Guide page 94 11S 3002B Appendix J Physical Measurements Figure 8 10 Physical Measurements...
