Fast 973P Series, Руководство оператора

Страница: 36 / 68

36
WARNING
Do not dispose of it in the farmyard or in
drainage ditches.
Fig. 53 CONTROL SYSTEM
20. Chemical Circuit Control
System:
Sprayers are equipped with
chemical circuit control com-
ponents that are mounted
on the back of the center
section. When equipped
with the automatic circuit
controller, the valves, fl ow
meter and solenoids are all
mounted on the plumbing
board.
21. Mix only the quantity of
spray required for the job.
Excess chemicals are diffi
cult
to store and dispose of. Do
not dispose of them in the
farmyard or your drainage
system. They will contami-
nate these areas.
22. Store chemicals only in their
original containers under lock and key to prevent
children or animals from touching them.
23. Be very careful to wear the proper protective
gear such as rubber gloves and goggles to
protect yourself. Thoroughly wash all protective
gear with a good detergent after use to remove
all chemicals.
24. Never allow chemicals or solutions to touch the
skin. Some can be absorbed through the skin.
Should such a contact occur, fl ush the aff ected
area immediately with clear water. Wash the
area thoroughly with detergent to remove any
residue.
25. When spraying is done, the machine should
always be rinsed. Follow this procedure:
a. Add 25 to 50 gallons of water to the tank.
b. Run the pump, wash circuit and agitator for
5 minutes to circulate and rinse the inside of
the tank.
c. Spray the rinse thinly over the previously
sprayed fi eld.
26. When spraying is fi nished for the season or when
switching chemicals, wash the sprayer using the
method described in the Maintenance Section.
WARNING