FangLing F2100B/T, Руководство по эксплуатации и установке

Страница: 14 / 147

Chapter 1 F2000 Series Control System Introduction
5
control arcing signal, check for location.
23) Plasma arc controlling supports two close arc THC ways of speed and distance to
make the machine more stable and safer.
24) Support edge cutting. It can save the preheat time for the thick steel plate.
25) Movement speed can be real-time acceleration, deceleration.
26) According to plate thickness, the cutting speed is automatically restricted by a
speed limit in the corner, effectively preventing over burn.
27) Select row and column manually.
28) Dynamic/static illustration of the process, graphics zoom in / out, dynamically
tracking cut-off point under zooming state.
29) DSP as core can control the machine move in high speed accurately, stability and
in low noise.
29) Starting speed and acceleration can be set by your convenience.
30) Automatically memorize the working situation and the last cutting point when
power off.
31) "Cutting offset" function can avoid waste the steel plate when the nesting of the
plate is calculated wrong.
32) Set up different administration authority and the corresponding password to
safeguard the interests of equipment manufacturers.
33) Long-distance remote control can control the machine to move forward,
backward, left, right and cutting start, stop and so on (optional configuration).
34) Plasma arc controller support two modes of close arc THC: rate and distance,
making machine more stable and safer.
1.3 Technical Indicator
1) Control Axis: 2 axis linkage(3 axis customizable)
2) Control accuracy: +/-0.001mm
3) Coordinate range: +/- 99999.99mm
4) Max pulses: 200 kHz. Max speed: 15,000 mm/m
5) Max lines of code: 150,000lines
6) Max size of single code file: 4M
7) Max power of drive arc THC motor: 45W
8) Time resolution: 10ms
9) Working Voltage: DC +24V direct-current power input, power > 80W
。