FangLing F2100B/T, Руководство по эксплуатации и установке

Страница: 63 / 147

Chapter 7 Parameter Setting
54
When press
【
G
】
, after the system ignites to punch hole and continues to cut to the
suspend point, it will continue to cut. This should be the function of edge cutting hole.
This function will be especially useful when cut the thick steel plate. Thick steel plate
is hard to be punched holes and the punched hole will be also larger. If directly punch hole
in the cutting path, it will maybe affect the final production quality. Using edge cutting can
may accelerate the efficiency of punch holes, save cutting time and improve production
quality.
Of course, don’t use edge cutting, punch hole with lead-in is also a more effective
method.
7.3 Plasma Parameters
As shown in the figure 7.4, these are Plasma Parameters, which are related with the
precision of transmission shaft of the machine.
F1 Common F2 Flame F3 Plasma F5 System F6 Import F7 Export F8 Save
DelayBeforeArc 0.00 s
Pierce time 0.00 s
Torch up time 2.00 s
Arcing check time 15.00 s
Position check time 0.00 s
Position up time 0.00 s
Speed to lock THC 95.00 mmpm %
Distance to lock THC 5.00 mm
Lose arc delay 0.00 s
Watch arc enable No <->
F4 Powder
Fig 7.4 plasma parameters

Arc time
：
Before the arc starting, the system time to wait. At this point, all output I /O
are turned off. Enter any positive number, unit is s.

Pierce time: Perforation time. Enter any positive number, unit is s.