46
Problem description
Solution
The tuning display does not show anything or is
not working properly.
Try to use another steering wheel. If this is also
not working properly the CSL Elite F1® Set might
be damaged.
Check the pins inside the quick release of the
steering wheel, these must not be bent or dam
-
aged.
After switching on the CSL Elite F1® Set the auto
calibration is not working properly.
Make sure that you have updated your CSL Elite
F1® Set to the latest firmware version which can
be downloaded from the Downloads section of the
.
After playing a while the CSL Elite F1® Set seems
to become weaker or is fading.
When the motor temperature is close to the upper
limit the Tuning Menu values will be overwritten to
regular maximum values (not higher than 100 %).
Additionally, the motor power level is controlled by
firmware so that the FFB strength may fade in this
high temperature range but the motor will not be
damaged. This allows extending the duration of
driving before the motor has to completely stop
operating to calm down.
Let your CSL Elite F1® Set cool down before
continuing to use it.
After playing a while the CSL Elite F1® Set motor
has switched OFF.
When the temperature is exceeding the upper lim-
it the motor will be deactivated for a while until the
temperature is low enough (to protect the hard-
ware from damages).
Let your CSL Elite F1® Set cool down before con
-
tinuing to use it. Contact our customer support if
this happens consecutively.
Fan is always working in full speed even though
the CSL Elite F1® Set was just powered ON and
did not heat up due to driving yet.
In case of malfunctioning temperature sensor
the fans will work at maximum speed to protect
the hardware from overheat. Please contact our
customer support. Note: The room temperature
should be above 20°C.
After calibration run at startup of CSL Elite F1®
Set the attached steering wheel doesn’t go to cor
-
rect center position.
Please check your Tuning Menu settings, the val
-
ue for SPR (spring) must be higher than ‘000’ as
this effect is required to make correct centering.
Default value is ‘100’.
