![background image](http://html1.mh-extra.com/html/faltcom/ecii-se/ecii-se_manual-and-installation-instructions_3287934020.webp)
Manual FältCom ECII SE Eng
Page 20 of 36
1.
If required, reset all old settings:
2.
Enter phone number for alarm receiver 1:
<Area code + telephone number (max 20 digits)>
3.
Enter ID number for alarm receiver 1:
<ID-number (max 10 digits)>
4.
Enter phone number for alarm receiver 2:
<Area code + telephone number (max 20 digits)>
5.
Enter ID number for alarm receiver 2:
<ID-number (max 10 digits)>
For alarm receivers 3 to 6, use the keys:
,
,
and
instead
of under item 4 above.
These numbers automatically get the same ID number as alarm receiver 1.
NB! Do not forget to test the function by sending a test alarm.
If no ID number and/or telephone number have been programmed, a short signal only
will be heard in the loudspeaker when an attempt is made to send a test alarm.
7.1.4 Closing alarm button function
Breaking function is default. If the lift phone version with integrated alarm button is used it is
already connected to the lift phone alarm input. If the alarm button has closing function, the lift
phone must be programmed accordingly by programming:
Reset to breaking function by pressing:
7.1.5 Test alarm to test the installation
After completed installation, the lift phone must be tested with a test alarm. With the keypad
on the back of the phone, you may check that the alarm reaches secondary receivers, too.
1.
Press the alarm button in the lift cage and check that the alarm reaches alarm
receiver 1.
2.
Check that the alarm reaches alarm receiver 2 by pressing (in programming mode):
3.
If there are more alarm receivers, test them by substituting
in the sequence
above by
,
etc.