Manual FältCom ECII SE Eng
Page 13 of 36
3.
Fasten the lift phone with the 4 enclosed screws. If it will not be possible to access
the lift phone from outside the lift cage, cables must be connected and the lift phone
programmed before it is mounted.
6.2 Frame
mounting
1.
Mark and pre-bore the holes for the lift phone frame according to the enclosed drill
template. Drill the holes for the cables to the alarm button and telephone connection
according to the drill template.
2.
Fasten the frame first and then the lift phone with the enclosed screws, after the
cables have been connected and the lift phone have been programmed.
6.3 Mounting behind the car operating panel
This alternative is only possible if there is
already a prepared space for a lift phone behind
the button & display plate. There is a special
version of the lift phone which is specially
designed for mounting behind a button & display
plate.
Since the design of the display may vary, we are
not able to give exact mounting instructions
here.
Keep in mind that the microphone hole must
be aligned with a hole in the display plate. It
might become necessary to drill a new hole.
For the best sound quality, the distance between
the lift phone front plate and the display plate
should not exceed 1 mm
6.4 Connection to alarm button
1.
Draw a two-wire cable (max 10 m) from the lift’s alarm button and screw the wires on
to the lift phone’s terminal block at ”ALARM”.
2.
Fasten the cable with cable ties or cable clips on the outside of the lift.
Note that the alarm button in the lift cage is normally double-breaking, i.e. made for two
separate connections, one of them usually connected to a local bell and the other one used
