Manual FältCom ECII SE Eng
Page 10 of 36
On the lift phone’s front plate, there are two pictograms and two single colored LED (yellow
and green), which is normally off. The left LED becomes yellow when an alarm call is in
progress and the right LED becomes green when the alarm has been received by an alarm
centre and a speech connection is established. The green LED is also used to indicate
programming mode. The LED can be programmed to other light sequences, see section
Programming
for more information. Note that with a separate device, external pictograms can
be activated, se section
Connection of external pictogram
.
The lift phone can be mounted recessed in the cage ceiling/wall, or mounted in a frame,
which eliminates the need to make other holes than those for the cables.
Depending on the design of the button & display plate, it may also be possible to install the lift
phone in a prepared space behind the plate. There is a version of the lift phone with a
completely flat panel, specially intended for such mounting. Contact your local distributor for
more information.
The connection of the lift phone requires one cable to the alarm button in the lift and one two-
wire cable to the lift engine room for connection of a standard analogue telephone line. It is
possible to use a separate suspension cable of the type round cable or flat cable. As an
alternative, two unused wires in the existing cage cable can be used. It is very important that
the cable is fastened properly. For the separate suspension cable, there is a special mounting
kit, which includes the necessary mounting parts.
The FältCom ECII SE consumes very little power and can be supplied by the voltage from the
telephone line. Separate power supply is only required if several lift phones are connected to
the same telephone line or if the line voltage is below 32 VDC. See more under section
Technical Data
.
100 mm
100 mm
Loudspeaker mesh
LED
Microphone hole
Keypad
Terminal block
23 mm
Adjustment of sound
