EN
76
5.8
Wash speed selection
Use the
SELECT (Fig. 12)
button to select position
I, II or III (Fig. 12)
, each position corresponding to a feed
speed, with the following production rates.
HOURLY PRODUCTION
POSITION OF
THE
SWITCH
CCO-120
CCO-160
I
80 baskets/h
100 baskets/h
II
100 baskets/h
130 baskets/h
III
120 baskets/h
160 baskets/h
Remember that the quality of the wash depends on the speed of the appliance and the type of dirt to be
washed. Therefore, the wash speed should always be appropriate for the dirt on the dishes.
The quality of the dishwasher wash will depend on the wash speed (lower speed
higher quality wash), tank water temperature (55 ºC - 65 ºC), correct detergent dose
and rinsing (without detergent) prior to inserting the dishes in the dishwasher.
5.9
Wash process
The door must be closed for the wash cycle to start. For safety reasons,
if the door is open, the machine will not start the cycle.
▪
IF THE FEED BELT IS BLOCKED, REMOVE THE OBSTACLE BEFORE
RESTARTING THE APPLIANCE.
▪
BEFORE REMOVING OBJECTS THAT HAVE FALLEN INSIDE THE
MACHINE, THE APPLIANCE MUST BE AT A COMPLETE STANDSTILL AND
DISCONNECTED.
▪
DO NOT INSERT HANDS IN THE MACHINE WHILE IT IS RUNNING.
▪
TO AVOID THE RISK OF ENTANGLEMENT, DO NOT APPROACH THE FEED
MECHANISM, ESPECIALLY IF WEARING JEWELLERY OR LOOSE
CLOTHING.
▪
IN THE EVENT OF BREAKDOWN AND/OR THE INCORRECT OPERATION OF
THE MACHINE, SWITCH OFF THE APPLIANCE AT THE MAINS AND
REFRAIN FROM CARRYING OUT DIRECT INTERVENTION OR ATTEMPTS
TO REPAIR.
Once the appliance has reached the conditions required to start the wash and the dishes has been correctly
stacked in the baskets, the wash process is performed as follows:
-
Use the
SELECT (Fig. 12)
switch to select position
I, II or III (Fig. 12)
. After selecting the required
wash speed, press the
START/STOP
(Fig. 12)
button to start the basket feed belt. If the machine runs
for 10 minutes without detecting the entrance of baskets, it will automatically stop.
-
Once the feed belt is moving, the baskets can be inserted through the entrance of the appliance.
Before inserting the baskets, prepare the dishes correctly (See section
Preparation of dishes
). Do
not exceed the height limit of the machine entrance (390 mm) as this may lead to damage to the
machine and the elements to be washed.
-
When the wash process starts, the boiler automatic energy saving function is deactivated and the
heating is activated to obtain a rinse temperature between 80 ºC - 85 ºC. Sometimes the machine may
take a few seconds to return to the ideal operating temperature. In this case, an empty basket can be
inserted first so that the appliance starts to heat up before.
If, with the first basket, the rinse does not reach a temperature of 80 ºC - 85 ºC, do
not insert any baskets for a few moments and allow the machine to return to the
ideal operating temperature.
-
The baskets will come out through the appliance output opening and collect on the output bench. Allow
the dishes to dry naturally for a minute. The following health aspects should be noted:
Содержание Eco Concept CCO-120
Страница 6: ...ES 6 CCO 120 ECO CCO 120 ECO CDT 600 CCO 160 ECO CCO 160 ECO CDT 600 Fig 4 ...
Страница 7: ...7 Fig 5 Fig 6 Fig 7 ...
Страница 154: ...154 ...
Страница 155: ...155 ...
