77
•
The basket should be removed and the dishes handled with clean hands or wearing gloves in order
not to contaminate it. Be careful as the dishes will be hot.
•
Do not dry the dishes with kitchen towels or cloths that are not sterile.
•
Operators must strictly observe all hygiene requirements when handling clean dishes and cutlery.
-
Stop the machine at regular intervals in order to remove any waste which has collected in the trays of
the appliance.
5.9.1
Wash cycle
The machine cycle includes a wash, drainage and a final rinse, with an optional dryer.
The tank thermostat maintains the wash water temperature at between 55 ºC - 65 ºC and motor pumps
circulate this water with detergent towards the wash arms. The jets of water reach the dishes from different
directions in order to guarantee a uniform wash.
The wash system starts when the wash actuator located in the rear internal part of the machine detects a
basket, and stops automatically when there are no baskets to be washed.
There is a drainage zone between the wash zone and the rinse zone which allows the detergent to drain
off the dishes towards the wash tub.
In the rinse zone, the baskets are rinsed with mains water heated to between 80 ºC - 85 ºC, mixed with
rinse aid to remove the detergent from the dishes, which at the same time regenerates the wash tank water,
thus reducing the level of dirt in the tank.
The rinse system starts when the rinse actuator located in the rear internal part of the machine detects a
basket, and stops automatically when there are no baskets to be washed.
An optional drying module is available for heating and expelling air at a temperature of 55 ºC - 65 ºC so
that the dishes come out completely dry. The dryer is automatically deactivated several minutes after the
last basket has come out.
If the water input temperature is lower than the specified temperature, the times
required to return to the operating temperatures will increase and productions
rates will be lower.
5.9.2
Limit switch / Micro switch
During the wash process, baskets may collect on the dishwasher output bench. When these reach the end
of the dishwasher output bench, the micro switch/limit switch is activated and the machine stops. The
machine will continue with the wash when the baskets are removed from the output bench and the limit
switch is released.
5.9.3
Emergency push button
The appliance has an emergency red and yellow push button
ES (Fig. 3, Fig. 4),
it is easily identifiable
,
and simple to connect to permit the installation of an extra external emergency button as required.
ONLY USE IN THE EVENT OF EMERGENCY
.
PUSH BUTTON OFF
PUSH BUTTON ON
RESET
Press the emergency button to switch off the machine which will stop operating completely.
When the emergency button is pressed, the green circle around the button (visible when the button is
deactivated) disappears.
To reset the emergency button, turn it in either direction until it is no longer pressed in.
Any basket that is in the appliance when the machine is stopped should be reinserted as the wash has
been interrupted and not completed correctly.
Содержание Eco Concept CCO-120
Страница 6: ...ES 6 CCO 120 ECO CCO 120 ECO CDT 600 CCO 160 ECO CCO 160 ECO CDT 600 Fig 4 ...
Страница 7: ...7 Fig 5 Fig 6 Fig 7 ...
Страница 154: ...154 ...
Страница 155: ...155 ...