A
A
CCESSORY
CCESSORY
C
C
ONNECTIONS
ONNECTIONS
R
ADIO
R
ECEIVER
C
ONNECTIONS
:
Radio Controls may be connected to the Radio Inputs to control the gate operator. When a Radio Control is active, the Radio
LED will light.
M
AG
L
OCK
& S
OLENOID
L
OCK
C
ONNECTIONS
:
Magnetic and Solenoid Locks may be connected to the controller and utilize a 2 second delay on open to help dissipate
magnetic current or solenoid power for smoother openings.
Radio Input:
1. Allows Radio Controls to activate the gate and provides
24VDC.
2. NOTE: Wireless Edge Sensor Receivers should be
connected to the Edge Terminals. See page 19.
Connecting Generic Radio Receivers:
1. Connect Radio Relay to RADIO N.O. and RADIO
COMMON.
2. If the Radio Receiver uses 24VDC, connect Radio
Power to RADIO PWR +24VDC and RADIO PWR -
24VDC.
Connecting FAAC XR2 Radio Receivers:
1. Connect XR2 N.O. relay contacts to RADIO N.O. and
RADIO COMMON.
2. Connect XR2 Power + to RADIO PWR +24VDC and
XR2 Power - to RADIO PWR -24VDC.
Generic Radio
Receiver
MagLock & Solenoid Inputs:
1. Allows Maglocks and Solenoid Locks to be connected to
the gate operator with a 2 second delay to open.
2. Maglocks use a NC relay contact. Solenoid Locks use a
NO contact. Power must be applied externally.
Connecting Solenoid & Maglocks:
1. Set Master and Slave DIP Switch 10 to ON.
2. Connect Solenoids to the external power supply and
Solenoid Com and N.C. outputs following the schematic
on the left.
3. Connect Maglocks to the external power supply and
Maglock Com and N.C. outputs following the schematic
on the left.
Switch
10
FSW900 Swing Gate Operator
23
MAGLOCK
SOLENOID
XR2
