![background image](http://html1.mh-extra.com/html/faac/fsw900/fsw900_manual_3212782010.webp)
G
G
ATE
ATE
O
O
PERATOR
PERATOR
I
I
NSTALLATION
NSTALLATION
G
ATE
O
PERATOR
L
OCATION
:
Use the following steps to locate the standard position of the gate operator. The charts may be used for alternate locations.
1. D = 35” from hinge center straight back.
2. E = 11” from D to Operator Output Shaft.
3. DISTANCE = 45” from gate to wall.
C
ONCRETE
P
AD
S
IZE
& L
OCATION
:
The FSW900 vehicular gate operator is designed to be mounted on a concrete pad. Select a location for the gate operator to
be installed. For pad location and size:
1. Determine the location for the operator to be installed. Determine the location of the output shaft as described above.
Then determine the location of the concrete pad following the drawing below
2. Follow all local building codes to determine the required depth of the concrete pad. The average concrete pad should
be 24” wide x 28” long x 24” deep. Extend the pad 4” above ground.
3. When the exact location of the operator can be predetermined, all conduits may be located in the concrete pad
terminating directly under the operator. Extend each conduit a minimum of 1” above the level of the concrete pad. See
the Conduit Location diagram below. It is suggested to install a minimum of four (4) conduits: (1) High Voltage Conduit,
(1) Low Voltage Conduit , (1) Loop Lead Wire Conduit, (1) Accessory Conduit.
4. When the exact location of the operator can not be predetermined, bring all conduits up to one side and terminate in a
Bell Box. Make connections to the operator using water-tight flex conduit.
5. Form the concrete pad and pour concrete. Allow the concrete to cure for 48 hours before removing forms and mounting
the operator.
6. Do not place mounting bolts in the concrete while pouring. Bolts may drift in wet concrete making the operator location
inaccurate.
A
B
Long Arm
E
C
Short Arm
D
Distance
A
B
C
D
E
Dist
46” 35.5” 29.5” 35” 11” 45”
46.75”
35.5”
33.5”
42”
11”
37”
46.75” 37” 31.5” 40” 11” 41”
47.25”
37.25”
30”
37”
11”
45”
47” 35” 29.5” 32” 11” 45”
42.5”
33”
26.5”
28.5”
11”
41”
A
B
C
D
E
Dist
34.5” 34.75” 29.5” 35”
14”
43”
44”
36.5”
32.5”
42”
14”
32”
44” 37” 30.5” 40” 14” 40”
45”
37”
30.5”
37”
14”
43”
44.75” 35.75” 29.5”
32”
14”
44”
41”
39”
27.5”
28.5”
14”
41”
24”
4”
28”
24”
12”
12”
8”
20”
24”
28”
Available
Conduit
Area
FSW900 Swing Gate Operator
10