G
G
ATE
ATE
O
O
PERATOR
PERATOR
I
I
NSTALLATION
NSTALLATION
G
ATE
O
PERATOR
D
IRECTION
:
The gate operator uses a DIP switch setting to determine the open and close direction. To set the Open/Close direction:
1.
Turn power OFF.
Use the power switch on the side to assure AC and Battery power are both OFF.
2. Standing inside the gate looking at the gate operator, determine if the gate opens to the LEFT or RIGHT.
3. If the gate opens to the LEFT, move DIP SWITCH 6 to the Left.
4. If the gate opens to the RIGHT, move DIP SWITCH 6 to the Right.
L
IMIT
S
WITCH
S
ETUP
:
The gate operator uses a limit switch assembly to adjust the distance of travel. These adjustments must be made before the
operator can be used. To adjust the distance of travel using the limits:
1. Move the open and close Limit Cams to the approximate
location.
2. Turn the operator ON and give it an open command. Let it
run until it gets to the open position. Give the operator a stop
command when the gate reaches the full open position.
Rotate the Open Limit Cam until it activates the switch. The
switch will click when activated. Tighten the Limit Cam screw
if needed.
3. Give the operator a close command. Let it run until it gets to
the close position. Give the operator a stop command when
the gate reaches the full close position. Rotate the Close
Limit Cam until it activates the switch. The switch will click
when activated. Tighten the Limit Cam screw if needed.
4. Run the operator again and fine tune the Cam positions.
5.
Make sure each limit cam hits the switch cleanly
.
Opens LEFT
Switch 6:
OFF
Opens RIGHT
Switch 6:
ON
FSW900 Swing Gate Operator
12
TOP CAM:
CLOSE
for Left hand op
.
OPEN
for Right Hand op.
Limit
Cam
Screw
BOTTOM CAM:
OPEN
for Left hand op
.
CLOSE
for Right Hand op.
