![background image](http://html1.mh-extra.com/html/faac/estate-swing/estate-swing_instruction-manual_535564019.webp)
NOTE: Before beginning the one touch learning procedure be sure to have full open and full
closed stop points* set up.
These will let your gate know where to stop during the learning
process. Make sure that the leaf or leaves are in the full closed position.
While the 5 function LEDs (A,B,C,D,E in picture) are lit stead-
ily, briefly press (about 1 second) the
P2
button. [
If P2 is pressed
for 3 seconds the opener enters the manual learning mode
]
The operator or operators start the opening maneuver, and the
function LEDs begin flashing.
Wait for the operator or operators to reach the opening stops. The
learning procedure has finished.
Press P1 once more to exit the
learning mode before attempting to operate the opener.
You may now test your gate opener or continue on with
changes to the factory speed, force, delay settings.
To test
your opener, briefly touch a wire from terminal 1 to one
of the negative terminals (12, 13, 14, or 15).
#
%
$
Enter the programming mode by pressing
P1
6 times until all 5 LEDs (A,B,C,D,E) are
lit. This is the learning mode.
$
$
Press for
1
Second
Single
Dual
1
2
1
2
Leaves will move from
closed to open
Leaf will move from
closed to open
* Stop points are structures meant to come in contact with and/or stop the gate at the required points.
Wood or metal stakes driven in the ground often make good stop points. For one-touch programming
the stop points must stay in after programming. To program without open stop points use manual pro-
gramming (on the next page). Closed stop points are always needed.
Содержание Estate Swing
Страница 1: ...Featuring ...
Страница 34: ... ...