FAAC Estate Swing, Инструкция по эксплуатации

Страница: 11 / 46

$+
1.
Set up closed stop points for your gate.
The closed stop points can be a plate on
the end of the gate that comes in contact
with an adjacent post or an industrial door
stop. (Many gates need an extension piece
added to make contact with the doorstop.
Examples of stops
Examples of industrial
door stops
2. Using the method on the previous page, determine your
5” x 5” setback. Once it is determined where your post
mounting bracket will be placed, use a C-clamp to hold the
post mounting bracket in place on the post.
3.
Check your operator arm. The pin should be stopped on the front part of the operator arm. If
the pin is not, turn the manual release key in the front lock hole clockwise until it reaches the
front stop position.
Extend the operator pin in
this manner ONLY. Any
other method may damage
the arm.
NOTE: The front
stop position IS
NOT THE FULL CLOSED POSITION,
it is the common point of ref-
erence for counting manual turns.
!