![background image](http://html1.mh-extra.com/html/faac/estate-swing/estate-swing_instruction-manual_535564017.webp)
-
.
J2 -
This terminal on the master board is used for connecting a transformer for powering. Transform-
ers can be used up to 1000’ away and connected with 16 gauge direct burial low voltage wire.
Slave Board Power—
On the slave board it is used as communication with the master board
and powering from the master board.
Connect the slave board to the master board using 16
gauge low voltage wire. This wire must be run across the driveway and can be up to 100
feet in length. Terminal 6
must
connect with the
right side
of J2 on slave board,
Terminal 15
must connect with the
left
side of J2 on the slave board as shown in the above diagram.
J3 -
Actuator Connections—
This terminal is used to connect the operator arm to the control
board both on the master and slave side.
IMPORTANT: Follow the above chart for wire col-
ors. DO NOT EXTEND OR SHORTEN THE ACTUATOR WIRES
J4 -
This terminal is for connecting the support battery on both the master and slave side.
NOTE:
Al-
though batteries are provided with the system, they do not come fully charged.
J5
- 5 - Pin set for FAAC receiver plug in
(instructions for receiver installation on Page 29)
F1
- Fuse between the battery and the operator arm.
Caution!
Do not reverse the polarity of the wires
connecting the master and slave board! This will cause
permanent damage to both boards and will void the
warranty.
Caution!
Содержание Estate Swing
Страница 1: ...Featuring ...
Страница 34: ... ...