![background image](http://html1.mh-extra.com/html/faac/e600/e600_manual_3131671009.webp)
9
15°/20°
ENGLISH
7.3 Operator
When you have assembled the rear fitting to the sliding guide
and finished installing the sliding guide, you can install the
operator:
1) While keeping the operator inclined at 15/20° (Fig. 20), insert
the gearmotor shaft in the coupling on the rear fitting of the
sliding guide and make the fins (Fig. 19 ref.
)
near to the
seats at the bottom of the operator base (Fig. 19 ref.
).
2) Turn the operator in the direction of Fig. 20 until you reach
position of Fig. 21, and fit the pin in the hole of the rear fitting
(Fig.21 ref.
).
Fig. 19
Fig. 20
Fig. 24
Fig. 23
Fig. 22
Fig. 21
7.4 Releasing the automated system
1) Define the height of the release knob, taking into account
that it must not be over 180 cm off the ground, and cut off
the excess section of rope.
2) Make a knot at the end of the rope and assemble the release
handle (Fig. 22).
3) Pull the release handle down and check if the door can be
moved manually (Fig. 22).
4) Pull the release handle horizontally in the direction of the
door (Fig. 23). Check if, when the handle is released, the
LOCK window under the carriage is red. Move the door
manually until you find the carriage’s hook-on point.
Attention: make sure that there are no persons, animals
or objects in the door movement area during the release
manoeuvre.
7.5 External release
If the automated system has an external release, finish
installing (see par. 6.3):
1) Cut the cable sheath to size (Fig. 24 ref. A).
2) Fit the cable inside the sheath and route it through the eyelet
of the door fitting (Fig. 24 ref. B).
3) Cut the cable to size and assemble it together to the internal
lever of the release handle (Fig. 24 ref. C).