- 22 -
5
5-1 Preparation
1.Attaching a rack for external water supply tank
You can attach the rack for external water-supply
tank to either right or left side of unit as desired.
Before shipment the rack for external water
supply tank is prepared for attaching to the right
side of unit.
If you would like to attach it to the left side of
unit, you need to reassemble the rack.
M4 screw
×
2 pcs.
①
②
③
④
(1) In case a rack is attached to the right side
1)
2)
3)
4)
5)
*
Loosen screws attached to the right side
with a cross slot screwdriver.
- M4 screw
×
4 pcs. - M6 screw
×
4 pcs.
Attach temporarily the rack for external
water supply tank to the position
①
and
②
with supplied two of M4 screws as shown.
Fix the position
③
with removed four M6
screws.
Remove the screw which is attached in the
procedure 2), and fix the hole below
①
with it.
Fix the position
④
with remaining two M4
screws.
Tighten enough screws to attach the rack
surely. As the tank capacity is about 20L,
the tank cannot hold up its weight with
insufficient attachment and it may cause
the breakage of the unit or the tank rack.
Using the unit as
an environmental
chamber
Action item
Complete the procedure 1
~
11 all.
Set depending on your purpose.
Complete the procedure 2, 4, 6, 7, 8, 9, 10, 11, and 12.
Use the unit with turning on the [Manual Drain] key.
Operation
Using the unit as
a incubator
M4 screw
×
2 pcs.
M6 screw
×
4 pcs.
Rack for external water supply tank