DMP 64 Plus • Dante Controller
30
To send an SIS command to an AXI device connected to a DMP 64 Plus:
1.
Connect the DMP and Dante-controlled devices to the same network via their AT ports
(see
2.
Connect to the DMP via the DataViewer or HyperTerminal utility (see
3.
Use the
Set verbose mode
command to set the DMP to Verbose mode 3 (see
on page 46). Example:
Command
Response
w3cv
|
Vrb3
]
4.
Use the
Query available remote devices
on page 52) to receive a list of Dante devices that are currently connected to
the DMP. Example:
Command
Response
waexpr
|
ExprA
•
AXI-XTP-RoomA
]
AXI-XTP-RoomB
]]
NOTE:
This list is similar to the list displayed within Dante Controller.
6.
Use the
Enable remote connection for listening
command to display the remote Dante-
controlled device responses based on the list of devices provided in the response
in step 4 (see
Enable remote connection for listening
on page 52). Repeat if
necessary for all desired devices. Example:
Command
Response
wcAXI02-XTP-RoomA*1expr
|
ExprCAXI-XTP-RoomA*1
]
NOTE:
AXI devices can be set up for listening even if not currently connected to the
DMP unit.
8.
To verify that the DMP is listening to the correct remote devices, use the
Query remote
devices being listened to
command to display a list of all remote devices enabled with
Query remote devices being listened to
Example:
Command
Response
wlexpr
|
ExprL
•
AXI-XTP-RoomA
]
9.
Send the desired command to the AXI and confirm the correct response is received.
•
When entering a command, use the “
w
” character in place of the
<Esc>
key and the
“pipe” character (
|
) in place of a return. Failing to do so may cause the command
to fail.
•
The closing bracket (
}
) is necessary to successfully end a command before
attempting to send a new command. Example:
Command
Response
{dante@AXI02-XTP-
RoomA:wg40000*-10AU
|
}
|
{dante@AXI02-XTP-RoomA}DsG40000*-10
]
NOTE:
The DMP provides the tag showing the Dante-controlled remote device
name while the remote device provides the response for the SIS command.
